Argo Conquest Manuel d'utilisateur télécharger pdf (Page 17)

Argo Service Manual Engine System

Ontario Drive & Gear Limited. www.odg.com

PH. (519)- 662-2840 FAX (519)- 662-2421

EN-17

10. Reconnect the fuel line at the carburetor and secure with the hose clamp.

11. Secure the fuel line to the nylon clips at the front of the vehicle.

12. Assemble the lower metal air filter plate to the top of the carburetor. Photo EN-31

13. Assemble the plastic air filter base to the top of the previously installed metal back-

ing plate, Photo EN-32, being sure to reconnect the tube from the base to the air

breather assembly on top of the engine.

EN-31 EN-32

14. Reinstall the air filter element with foam precleaner, and assemble the cover to the

top of the engine.

15. Reconnect the main engine wire harness located between the engine and transmis-

sion.

16. Reconnect the starter cable at the electric starter and cover with the rubber boot.

17. Secure the main engine harness to the nylon clips between the engine and transmis-

sion.

18. Reconnect the ground wire from the negative battery post terminal to the engine.

19. Reconnect the choke cable assembly.

On Conquests manufactured prior to CB14606, slip the assembly back through the body

at the dash and secure with the molded panel nut. It was not required that the choke was

disconnected at the throttle/choke control panel for engine removal, but if it was, you will

need to reattach it at the linkage as well.

On Conquests manufactured from CB14606, reconnect the cable to the throttle/choke

control panel. It was not required that the choke knob was removed at the dash when the

engine was prepared for removal..

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 36 37

Pas de commentaire

Argo Conquest Manuel d'utilisateur Page 17